2024-08-08
Before driving, electric forklifts must undergo technical inspections:1. Check the height and density of the battery electrolyte. The liquid level should be 10-15mm higher than the partition, and the density should meet the requirements of the regionand season. Thevoltage of a single cel
CLICK MORE2024-08-06
1. Black smoke from exhaust(1) The diesel engine load exceeds the specified value. Reduce the load to within the specified range;(2) The fuel supply of each cylinder is uneven. Adjust the fuel injection pump;(3) Incorrect valve clearance and poor valve sealing lead to valve leakage and deterioration
CLICK MORE2024-07-31
When the electric forklift is moving slowly, the following electric forklift accessories can be checked as follows:1. Check whether the battery voltage of the electric forklift accessories is too low. If the voltage is OK, check whether the battery power is sufficient to replace the normal operation
CLICK MORE2024-07-29
In hot seasons, after a forklift is used frequently for a long time, the machine will become hot. At this time, the function of the forkliftradiator will be tested. If the forklift radiator is good, the forklift can work normally. TOOMOTOO reminds you: the forklift radiatorshould be well
CLICK MORE2024-06-19
1. Different types of forklift warning lightsForklift warning lights are a safety device used to alert personnel to the presence and operation of forklifts. These warning lights usually attract attention with bright beams or flashing patterns to reduce the potential risk of accidents. Here are some
CLICK MORE2024-02-01
1. Application of corrosion resistance and anti-corrosion technology of domestic forklifts The protection design, anti-corrosion technology and process level of domestic forklifts are relatively low. The fullness, smoothness, glossiness and adhesi
CLICK MORE2024-01-31
Bearings are important components in mechanical equipment. In order to ensure that the bearings can achieve ideal performance, correct installation and operation, and reasonable maintenance are very important. To extend the service life of bearings, three aspects of work n
CLICK MORE2024-01-30
Ⅰ.Five major reasons for forklift tire wear 1. Under a certain tire pressure, overloading the tire will increase its deflection and deformation, and increase the stress on the cords and cords, which can easily cause the cords in the sidewall to break, loosen, and delaminate the
CLICK MORE
LINKS:
Harber Metal