How do you remove a forklift tire?

1. first of all, start the machine, look for a relatively flat and open field, press down the arm lift lever, the use of arm support to make the front wheels off the ground, and then use the bracket to support the front axle near the side of the flat tire, and will be wedged in the rear wheels.

2. followed by the use of pry bars and other tools, dismantle the retaining ring and lock ring and then check whether the tire liner and rim surface adhesion.

3. Finally, use the pry bar and other tools to remove the tire from the rim.

The specific operations are as follows:

1. Unload the forklift. Park the forklift on a flat, hard surface with the forks lowered to the ground and the parking brake applied to stop the wheels.

2. Jack up the forklift under the outside door frame on the side where the tire is to be replaced, jack up the electric forklift to the point where the tire is still slightly in contact with the ground, and place padding under the front side of the forklift frame to prevent dropping.

3. Loosen the wheel nuts with a wheel nut wrench or other tool until the nuts can be turned by hand, but be careful to loosen the nuts in a diagonal order.

4. Jack up the forklift a little more until the tires are slightly off the ground, remove the wheel nuts and remove the front wheel assembly.

5. the front wheel assembly of the hub of that side placed on a flat, hard road surface, at this time, the road surface should be paved with wooden boards or blankets and other prevention of wheel sassafras mat, with the help of tools, press down on the tire, remove the two pieces of half a piece of the type of card springs, and then remove the retaining ring, remove the tire can be.