How to operate forklifts?

Forklift operation steps:

1. Check whether the gear has been reset and ignition.

2. Put down the handbrake (if the ground is uneven, step on the foot brake before stepping.)

3. If you continue to move forward, please step on the clutch (the leftmost pedal is a clutch, a brake in the middle, and the throttle on the far right). The right handle rod is used to select appropriate gears.

4. Move the fork up and down to the upper left. The pole moves up and pushes this pole. The front end of the fork will move up and down to press the upper right manipulating rod.

Precautions for operating forklifts

1. When driving, the bottom end of the fork should keep MM and door frames rear.

2. Do not raise the fork too high when driving. At the scene or on the way to enter and exit, pay attention to the crisis of barrier to the sky. When the carrier is driving, if the fork rises too high, it will also increase the height of the overall center of gravity of the forklift and affect the stability of the forklift.

3. After unloading, you should land for a fork to the normal driving position before driving.

4. When turning, if there are pedestrians or vehicles nearby, a signal shall be issued and a high -speed turning shall be prohibited. High -speed rapid turns can cause the vehicle to lose horizontal stability and turn over.

5. Internal combustion forklifts are strictly forbidden to go downhill when going downhill.

6. Non -special circumstances, the brake is prohibited from driving.

7. When the carrier is driving over 7 degrees and at a speed of one gear, it is not necessary to use a brakes in non -special cases.

For the eight ban on forklift operations, you can see the information. For more knowledge about forklift and forklift accessories, please continue to pay attention to this site!