Learn the basic steps of operation for forklift

Basic steps to operate forklifts:

1. Enter the forklift and deduct the seat belt. Link on the forklift from the left. Grasp the handle in front of the cab and grab the back of the seat. Step your feet on the bus auxiliary steps and then sit. After sitting down, tie the seat belt to ensure safety.

2. Start the forklift: Hold the steering wheel handle on the left hand, pull the power switching handle up in the right hand, insert the forklift key into the switch keyhole, gently twist the right to the right after the engine starts, and hold the in front of the forklift to insert the control lever in front of the forklift. Press down, and the front will be tilted.

3. Movement of the engine: Check the fuel gauge, check the water temperature meter, check the oil pressure meter, and check the mileage meter.

4. Check the steering light: whether it is in a normal working state, press the horn in the right hand to listen to whether the sound is loud.

5. Remove the handbrake: Hold the handbrake handle with your left hand, and hold the button on the upper end of the handbrake of the handbrake with your thumb. On the foot brake pedal.

6. Push the gear rod to start: Put your hand on the steering wheel and pinch the gear rod on your left hand, push the gear rod to the position of the 1st gear, change the steering wheel handle on the left hand, and then hold the shovel arm forward lever. Pull the shovel back to lean back (back) back, change the grip frame to the door to lift the fucking rod, and pull the control lever back to the rise. The stiffness of rising to the ground is less than 500mm.

7. When you are ready to start: look around to see that there are no people or things around the forklift, so as not to danger. After the whistle, the first gear started slowly.

8. Several key precautions:

Only drivers who have undergone systematic training and hold a forklift driving license can drive

Putting the goods should lower the cargo, and the door frame is leaned back

Pay attention to pedestrians, obstacles and potholes when driving, and pay attention to the gap above the forklift

When leaving the car, put the fork on the ground and place the gear handle in the vacant position. The engine is turned off and disconnected the power. When the hand is staged, the wheels must be used to stop the wheels when parking on the slope.