Forklift parts of the repair kit seals installation precautions

Forklift repair kit seals installation precautions: the following steps:

1. Before installing the forklift repair kit seals, to apply some lubricant to the lip to facilitate the installation and prevent the initial operation of burns, be careful to clean the surface inside the circle;

2. Can not be installed in the wrong direction and damage to the lip. In the lip of the seal if there is more than 50μm scar, it may lead to obvious oil leakage and thus failure;

3. Prohibit the mandatory installation of forklift truck repair kit seals, for example, not allowed to hammer the articulation into, be sure to use special tools such as a screwdriver, the first sealing ring will be pressed into the seat holes, and then use a simple cylinder to protect the lip through the spline part;

4. Strictly in accordance with the forklift repair kit seals service life replacement. Dynamic seal of the rubber seals use period is generally 3000-5000 hours, to the use of the period, should be replaced in a timely manner with a new forklift truck repair kit seals seals;

5. In the choice of replacement of forklift truck repair kit seals to choose a consistent size of the old. Select the same size of the seal, otherwise it can not guarantee the compression degree and other requirements;

6. In the replacement of forklift truck repair kit seals seals are not allowed to replace the old seals. The use of new seals, but also to carefully check the surface quality, to determine the absence of small holes, protrusions, cracks and grooves and other undesirable defects and have sufficient elasticity before installation into the body;

7. Before installation, should be strictly checked under the seal groove, remove dirt, grinding groove bottom and clean the parts of the open hydraulic system accessories, use special forklift repair tools to prevent metal sharp edge will be finger scratches;

8. In order to prevent the forklift repair kit seals seal ring damage caused by leakage, in the maintenance and installation must be operated in accordance with the procedures, in the daily operation of the forklift truck as far as possible not to overload for long periods of time or forklift fittings placed in a relatively harsh environment for a long period of time operation.